StorCase Technology 12-Bay 4U SCSI Ultra320 - Manual (Page 21)

16 Installation
StorCase Technology, Inc. InfoStation 12-Bay Installation Guide - Rev. A02
Installing a Non-StorCase RAID Battery into the InfoStation
CAUTION: Remove ALL power from the InfoStation before installing any Non-StorCase
RAID Battery. Refer ALL servicing to qualified service personnel!
Danger of explosion if the RAID battery is incorrectly replaced! Replace only
with the same or equivalent type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer's instructions.
NOTES: Please refer to RAID manufacturer's battery specifications. StorCase InfoSta-
tion RAID batteries are 3-cell NiMh, nominal battery voltage = 4.2V fully
charged, 1600 to 2100 mAh.
While performing the steps in this section, work on a soft surface to prevent
excessive shock to the InfoStation chassis.
The optional RAID Battery Bracket is designed for mounting a non-StorCase RAID battery into
the InfoStation 12-bay chassis. Contact StorCase for further details and ordering information.
Figure 18: Installing a Non-StorCase RAID Battery onto the
Optional RAID Battery Bracket
IFS12_26A
Non-StorCase
RAID Battery
(Not Included)
Optional RAID
Battery Bracket
(Not Included)
Mounting Screws
(Not Included)
Thumbscrew
Bracket Tab