StorCase Technology 12-Bay 4U SCSI Ultra320 - Manual (Page 14)

InfoStation 12-Bay Installation Guide - Rev. A02 StorCase Technology, Inc.
Installation 9
Figure 8: Removing the Access Panel
Removing the Chassis Access Panel
CAUTION: Remove ALL power from the InfoStation before removing the access panel(s).
The InfoStation contains NO USER SERVICEABLE PARTS inside the unit.
Warranty is VOID if any of the modules inside the InfoStation are opened.
Refer ALL servicing to qualified service personnel!
NOTE: A #2 Phillips screwdriver will be required for this procedure.
1. Unplug the InfoStation and verify that ALL cables have been disconnected.
2. Place the InfoStation on a soft clean surface to protect finish of the chassis.
3. Remove the ten (10) #6-32 Phillips Flat Hd. screws securing the access panel to
the InfoStation chassis (Figure 8).
4. Remove the access panel by carefully lifting the panel(s) off the chassis (Figure 8).
5. To reinstall panel, simply reverse the above mentioned steps.
Access Panel
(Right Side)
#6-32 Phillips
Flat Hd. Screw
(10 total)
InfoStation
Chassis