StorCase Technology 9-Bay 4U SCSI Ultra320 - Manual (Page 19)

14 Installation
StorCase Technology, Inc. InfoStation 9-Bay Installation Guide - Rev. B00
Figure 14: 4-Channel Backplane Configuration
I/O
Module
Terminator
Block
I/O
Module
Terminator
Block
Terminator
Block
IFS14_22
Terminator
Block
I/O
Module
I/O
Module
Configuring the InfoStation for 4-Channel
CAUTION: Remove ALL power from the InfoStation before removing the I/O module.
The I/O module contains NO USER SERVICEABLE PARTS inside the unit.
Refer ALL servicing to qualified service personnel!
NOTES: The InfoStation 9-bay supports daisy-chaining for Ultra160 applications
only.
Optional I/O interfaces are available as an upgrade. Contact StorCase for
further ordering information.
1. Unplug the InfoStation and verify that ALL cables have been disconnected.
2. Place the InfoStation on a soft clean surface to protect finish of the chassis.
3. Loosen and remove the two (2) #6-32 Phillips F. H. screws securing each I/O blank
plate to the InfoStation chassis (Figure 11).
4. Remove all three (3) I/O blank plates.
5. Remove access panel (as described on page 10).
6. Remove all the jumper blocks so that I/O modules (#2, 3, and 4) and terminators (#2,
3, and 4) can be installed. Correct 4-channel backplane configuration is shown in
Figure 14.