StorCase Technology 9-Bay 4U SCSI Ultra320 - Manual (Page 11)

6 Installation
StorCase Technology, Inc. InfoStation 9-Bay Installation Guide - Rev. B00
Figure 5: Removing the Power Supply Module
Locking
Thumbscrew
Handle
Power Supply
Module
IFS14_7
Removing the Power Supply Module
CAUTION: The power supply module contains NO USER SERVICEABLE PARTS inside
the unit. Warranty is VOID if module is opened. Refer ALL servicing to
qualified service personnel!
WARNING: DO NOT USE MODULE HANDLES TO LIFT CHASSIS! These handles are
specifically designed for the installation and removal of modules only!
NOTE: The power supply module is hot-swappable. The chassis may remain on
when removing and installing the power supply module.
1. Turn OFF power to the power supply module via the power switch located on the
module itself.
2. Loosen the locking thumbscrew securing the power supply module to the InfoStation
chassis (Figure 5).
3. Remove the power supply module by grasping handle outwards and pulling out from
chassis.
NOTE: Make sure the retainer clip (if installed) is not blocking the power supply
module handle (handle pivots outward). Damage to the retainer clip may
occur otherwise.
4. To reinstall power supply module, simply reverse above mentioned steps.
NOTE: Blank plate (provided) must be installed if module slot is left empty. Instal-
lation of the blank plate is necessary for proper cooling inside chassis.