StorCase Technology DE150i-SWC - Manual (Page 14)

DE150i-SWC User's Guide - Rev. B00 StorCase Technology, Inc.
Installation 7
INSTALLATION
Installing the Drive into the Carrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation provided with the
drive.
NOTE: A #2 Phillips screwdriver will be required during this procedure.
1. Remove the drive from its protective packaging.
2. Plastic Drive Bezel: If the drive came equipped with a plastic front bezel, it
must be removed.
3. SCSI Drive Termination: Disable or remove the termination resistor packs
from the drive. Termination is handled by an external terminator in the
DE150i-SWC receiving frame. Refer to the documentation provided by the drive
manufacturer for the location of these terminators or jumpers.
Installation
1. Attach the SCA I/O cable from the rear distribution board of the DE150i-SWC
carrier to the drive (Figure 6).
2. Carefully insert the drive into the carrier at an angle, cable-end first. Make sure
that none of the cables are pinched. Lower the front of the drive carefully
into place. Fasten the drive into the carrier with four (4) #6-32 Phillips Flat Hd.
screws provided.
3. Attach the provided cable cover with two (2) #6-32 Phillips Flat Hd. screws.