StorCase Technology DE100i-SWD - Manual (Page 16)

Kingston Technology Company DE100i-SWD User's Guide - Rev. C00
10 Installation
Mounting
Holes (Right)
Mounting
Holes (Bottom)
Front of Unit
Mounting
Holes (Left)
0086
IMPORTANT NOTE: In order to use remote ID selection from a computer or
expansion chassis, the Unit ID number on the Data Express
receiving frame must be set to '0' with the provided alignment
tool. Refer to the section "Selecting the Unit Number" later in
this section for the Unit ID selection procedure.
4. With the drive carrier locked in place inside the receiving frame, install the Data
Express into the 5.25” drive opening in the computer or expansion chassis.
Use the appropriate guides to position the Data Express, and fasten it into
place with the four 6-32 x 1/4” screws provided. Figure 9 illustrates the location
of the mounting holes. Mounting holes are provided on each side and the
bottom of the receiving frame to accommodate a variety of mounting
configurations. Use the mounting holes which best suit the computer or
expansion chassis configuration.
Figure 9: Receiving Frame Mounting Holes
5. Adjust the front of the receiving frame so the carrier slides freely in and out on
the receiving frame guides. The position of adjoining peripheral units may
require adjustment.
6. To connect the drive to a Remote Activity LED in the computer system or
expansion chassis, connect the appropriate cable(s) to the receiving frame
mother board as shown in Figure 5. Connect J6 Pins 4 and 6 to a remote
activity LED.
7. Connect the I/O interface cable from the host adapter to the receiving frame.
The pin 1 indicator on the cable must be properly aligned. Refer to Figure 5
for the correct pin 1 location.
Make sure that only the last SCSI device is terminated. The Differential Data
Express does not contain on-board SCSI termination. If it is the last SCSI
device, set the termination from the expansion chassis.