StorCase Technology DE100i-SWD - Manual (Page 14)

Kingston Technology Company DE100i-SWD User's Guide - Rev. C00
8 Installation
Figure 7: Typical SCSI ID Select Connections (2mm Drive Pins)
TYPICAL 2MM DRIVE ID PIN CONFIGURATION
Figure 7 illustrates a typical SCSI ID select connection to a drive with 2mm ID select pins.
The wires on the wire harness connect to the positive pin (or signal pins) on the disk drive. In
some cases, the drive manufacturer will label the signal pins as Pin 1, 3, 5, 7, (instead of 0,
1, 2, 3 as shown in Figure 7 below). Also, in some cases, the even-numbered Pins 2, 4, 6
are used for Ground.
Attach the ID select cable to the drive using the 2mm connectors. Align the “ID0” pin with the
black wire. Attach the other end of the ID select cable to the connector (J3) provided on the
signal distribution board, located inside the carrier. Refer to the manufacturer’s
documentation to disable termination on the drive.
Black (ID0)
Brown (ID1)
Red (ID2)
Data Express ID
Select Interface
(Inside Carrier)
Signal
Distribution
Board
Wide
Differential
ID Select
Cable
Pin 1
(Pins vary on each drive model. See Drive
Manufacturer's Manual.)
Orange (ID3)
Yellow (LED)
T O
To Drive ID
Select Pins
To ID0
To ID1
To ID2
5-PIN WIRE WRAP
CONNECTOR (Provided). Use
in place of ID Select Cable
if there is not enough space.
Pin 1
To ID3
To LED
Black (ID0)
Brown (ID1)
Red (ID2)
Orange (ID3)
Yellow (LED
Activity)
Wide Differential ID
Select Cable (from Data
Express Signal
Distribution Board)
Typical Drive Wide Differential ID Select Pins
0
1
2
3
LE
D
Disk
Carrier
0142