StorCase Technology DE75i-SW160 - Manual (Page 20)

DE75i-SW160 User's Guide - Rev. B00 StorCase Technology, Inc.
Installation 13
3. A "u" will be displayed once the drive has completed spin down and is ready to be
removed from the receiving frame. The indicator will return to the SCSI ID number
when the carrier is removed from the receiving frame.
4. Use the alignment tool supplied with the DE75i-SW160 to select the ID number of
the disk drive. Refer to Figure 10 for the location of the unit ID select switch
inside the receiving frame.
WARNING: Selecting an invalid ID number, or selecting the same unit ID number on
different devices may cause unpredictable results and the computer
system may not recognize the installed device(s). If the computer
system can not recognize the boot disk, the computer system may fail
to start-up properly.
5. After selecting an appropriate unit ID number, replace the DE75i-SW160 carrier in
the receiving frame, and LOCK IT IN PLACE.
6. If the DE75i-SW160 has been installed into an external expansion chassis, verify
that power is on to the chassis and that the last device in the SCSI daisy chain is
properly terminated.
7. Reboot the computer system.
Figure 10: Unit ID Select Switch Location