beautypg.com

Installing the receiving frame, Figure 8: receiving frame motherboard option pins – StorCase Technology DE75i-SW160 User Manual

Page 17

background image

StorCase Technology, Inc.

DE75i-SW160 User's Guide - Rev. B00

10

Installation

Installing the Receiving Frame

The drive should be installed into the carrier before installing the receiving frame into the

mounting bay of a computer or expansion chassis.

NOTE:

Use a #2 Phillips screwdriver during this procedure.

1.

Turn OFF power to the computer.

2.

Open the computer system according to the manufacturer’s instructions. If

necessary, temporarily remove any expansion boards that may make installation

difficult.

3.

To select the DE75i-SW160 unit ID remotely through the computer system or

external expansion chassis, the appropriate cable from the system must be

attached to option Pins 1-8 on the rear of the receiving frame (Figure 8). Set the

unit ID to "0" for remote ID selection (Figure 10).

Figure 8: Receiving Frame Motherboard Option Pins

4. With the drive carrier locked into place inside the receiving frame, install the DE75i-

SW160 receiving frame into the drive opening in the computer or expansion chassis.

Use the appropriate guides to position the DE75i-SW160, and fasten it into place with

four (4) #6-32 x 1/4” screws provided. Figure 9 illustrates the location of the mounting

holes. Mounting holes are provided on each side and the bottom of the receiving frame

to accommodate a variety of mounting configurations. Use the mounting holes which

best suit the computer or expansion chassis configuration.