StorCase Technology DE75i-SWC - Manual (Page 19)

12 Installation
StorCase Technology Inc. DE75i-SWC User's Guide - Rev. B00
8. Connect the power cable from the DC power supply in the computer or
expansion chassis to the power connector on the DE75i-SWC receiving
frame. Refer to Figure 5 for the DE75i-SWC receiving frame power
connector location.
9. Replace any expansion boards that may have been removed earlier.
Replace the system cover according to the manufacturer’s instructions.
10. Reconnect any system or peripheral cables removed earlier.
11. Turn ON power to the computer. If the installation has been successful, and
all cables have been properly attached, the system should boot normally.
Although the computer may not recognize the DE75i-SWC yet, the front
panel LED indicator on the receiving frame should illuminate.
NOTE: The lock on the DE75i-SWC receiving frame functions as a lock
and a DC power switch for the carrier unit. The lock must be
engaged (turned counterclockwise) in order to supply power to
the carrier and installed drive unit.
12. The new drive may need to be formatted or initialized prior to use with the
operating system and applications software. Refer to the drive and/or
computer manufacturer's documentation for formatting information.
Selecting the Unit ID Number
1. Verify that power is turned on to the DE75i-SWC receiving frame by turning
on the computer or external expansion chassis. A number should appear
in the unit display window if the carrier is locked into place.
2. Unlock the DE75i-SWC drive carrier and remove it from the receiving frame.
A "u" will be displayed initially when the unit is unlocked but will return to a
SCSI ID number when the carrier is removed from the receiving frame.
WARNING: Unlocking the carrier unit switches DC power off to the
drive. Since disk drives require a short amount of time to
spin down, allow about 15 seconds before pulling the
carrier unit out of the receiving frame to avoid possible
damage to the drive.
3. Use the alignment tool supplied with the DE75i-SWC to select the ID number
of the disk drive. Refer to Figure 9 for the location of the unit ID select
switch inside the receiving frame.
4. After selecting an appropriate unit ID number, replace the DE75i-SWC
carrier in the receiving frame, and LOCK IT INTO PLACE.