StorCase Technology DE75i-SWC - Manual (Page 14)

Installation 7
DE75i-SWC User's Guide - Rev. B00 StorCase Technology Inc.
DE75i-SWC INSTALLATION
Installing the Drive in the Carrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive
shock to the drive being installed. Also refer to the manufacturer's documentation
provided with the drive.
NOTE: A #2 Phillips screwdriver will be required during this procedure.
1. Remove the drive from its protective packaging.
2. Plastic Drive Bezel: If the drive came equipped with a plastic front bezel,
it must be removed.
3. SCSI Drive Termination: If the drive contains onboard termination,
disable it. Termination is handled by an external terminator in the DE75i-
SWC receiving frame. Refer to the documentation provided by the drive
manufacturer for termination information.
Installation
1. Carefully insert the drive (Figure 6) into the carrier so that the I/O connector
is flush with the rear of the carrier. Do not fasten the drive into place until
the drive cover has been installed as described in the following step.
2. Install the drive cover by inserting the front lip of the cover under the front
inside face of the carrier. Carefully push down on the rear of the cover so
that the side flanges align with the outside of the carrier as they appear in
Figure 6. The drive cover should sit flush with the top and rear of the
carrier. The drive and the I/O connector must also be flush with the rear of
the carrier. Fasten the drive and the cover into place with four (4) #6-32 x
1/4" Phillips machine head screws.