Speck Electronics LiLo - Manual (Page 32)

Chapter 3 Operation Section 28
This ¼” TRS jack is available
as an unbalanced output
for an external stereo VU
meter and is selected with
the VU Meter Select
switch on the master
module. The tip of the
stereo jack is the left VU
signal, and the ring of the
jack is the right VU
signal.
The use of this output
connector does not affect
the operation of the VU
meter pod on the LiLo.
Each of the four Aux Send
channels have an active-
balanced ¼" TRS jack to
interface to the input of an
effects device.
Each Aux Return provides stereo balanced ¼" TRS
jacks for connection from the outputs of a stereo
effects device. In order to operate the stereo aux
return as a mono return, plug into the left input jack only.
The DC power cable that comes from the power supply connects to this 9 pin
circular connector. This connector and its respective plug is keyed so they will
only fit in one direction. For power supply installation instructions, refer to
the Interface & Setup Section in this manual.
The following connector illustration (Figure 12a) and chart (Figure 12b)
represents the DC voltages to the 9 pin circular connector required to power
the LiLo.
4
7
2
8
1
6
9
3
5
PIN 1 0 VDC
PIN 2 +17.5 VDC
PIN 3 +17.5 VDC
PIN 4 0 VDC
PIN 5 -17.5 VDC
PIN 6 -17.5 VDC
PIN 7 0 VDC
PIN 8 +6.5 VDC
PN 9 N.C.
50. VU Meter Output
51. Aux Send Jacks
52. Aux Return Jacks
53. DC Power Input
Connector
Figure 12a
50 53 54
51 52
Figure 12b