Speck Electronics LiLo - Manual (Page 31)

Chapter 3 Operation Section 27
The balanced group outputs are adjusted by the Group 1 and Group 2 masters
[39] on the master module.
Active-Balanced outputs are standard on the group outputs but may be
ordered with transformer-balanced outputs.
Each group channel has ¼" TRS send and return insert jacks. The insert jack
provides line level inter-stage access to the group bus before (pre) the Group
Master level control. This means that any device interfaced to these jacks will
not be affected by any adjustments of the Group Master control.
The insert jacks may be utilized to connect processors such as limiters,
equalizers, or noise reduction.
The active-balanced electronic circuitry of each group insert return is
completely bypassed via a relay until a plug is inserted into its respective
insert return jack.
These balanced ¼" TRS jacks are available for hooking up a power amp or
powered speakers. The signal present at these jacks is adjusted by the
Monitor Master control on the front panel.
These active-balanced 1/4"
TRS connectors allow the
interface of an external stereo
signal, such as a DAW, DAT,
CD recorder/player, or any
stereo line level source. These
inputs are selected with the
Monitor Select [26] on the
master module. The 2T and
DAW returns may be operated
in mono when a single signal
is plugged into the left input
jack only.
46. Group Output
Connectors
47. Group Insert Jacks
48. Monitor Output Jacks
49. DAW and
2T Return Jacks
46 47 48 49