Speck Electronics LiLo - Manual (Page 27)

Chapter 3 Operation Section 23
Aux Return Section
There are two aux return sections incorporated into the
LiLo. Each stereo return includes a stereo Return
Level control, Pan control, Mix Assign, Group
Assign, and in-place Solo switch.
This dual pot simultaneously and equally adjusts the
left and right aux return level.
This center detent control acts as the left/right balance
for any stereo output effects device connected to an
aux return. When a mono output effects device is
connected to the aux return, then this control would act
as a traditional pan.
The Mix Assign switch, in conjunction with
the Pan control, allows an aux return to be
mixed to the left/right main output.
The GRP 1-2 pushbutton switch allows the aux
return to be assigned and mixed to the two
individual subgroups. This switch operates
under the control of the pan/balance control.
Depressing this switch allows you to isolate
any aux return to the monitor outputs while
maintaining stereo perspective. The source for
the in-place solo circuit is post (after) the aux
Return Level control. This allows you to solo
multiple effects returns while retaining their
relative levels. A red LED above this switch, as
well as the master Solo LED, will illuminate when the
return is soloed. 38. Solo
37. Group Assign
36. Mix Assign
35. Pan/Balance Control
34. Aux Return Level
34
35
38
37
36