Speck Electronics LiLo - Manual (Page 26)

Chapter 3 Operation Section 22
This trim pot adjusts the level of any external
stereo source connected to the DAW returns on
the rear panel. This could be the stereo mix of
a DAW or any other stereo source. This return
is selected with the DAW, or the Mix+DAW
Monitor Source Select switch.
The factory setting for this pot is about the
2 o'clock position. A small flat blade
screwdriver can be used to adjust this pot.
This controls the level of any stereo source connected
to the 2T returns on the rear panel. This could be a
DAT recorder, CD player/recorder or any stereo audio
signal. This return is selected with the 2T Monitor
Source Switch.
This control adjusts the overall solo listening
level to the monitor outputs. The adjustment
of this control permits the volume of a soloed
signal to match the level of the normal stereo
mix. An associated LED illuminates when a
solo switch on any input channel, group assign,
or aux return is soloed.
This switch selects the source to the VU meter
pod as well as the ¼” VU output on the rear
panel. This switch can be either the "L-R Mix"
outputs or "Group 1-2" outputs. Two yellow
LED's display the status of the selected
outputs.
The four Aux Masters provide master level control to
the balanced aux send outputs on the rear panel.
When matched with an effects unit that is properly
operated at a professional input level of +4 dbu, the
optimum setting for this pot is typically anywhere
from 2 to 3 o'clock.
29. DAW Return Level
30. 2 Track Return Level
31. Solo Master
32. VU Meter Select
33. Aux Masters
29
30
31
32
33