Southbend TVES-30SC - Manual (Page 11)

E LECTRIC T RU V ECTION O VENS
I NSTALLATION
O WNER ’ S M ANUAL 1194659 REV 1 P AGE 11
IN
S
T
A
L
L
A
T
IO
N
Step 3: Installation of Restraint (Only for Ovens with Casters)
NOTICE
For an appliance equipped with casters, adequate means must be provided to limit the movement of
the appliance without depending on or transmitting stress to the electrical conduit. The restraining
means should be attached to a frame member on the back of the unit and the appliance should be
installed using flexible conduit.
1. Secure the restraining-device bracket (item “B” in the following illustration) to a wall stud located as
close as possible to the appliance connector inlet and outlet connections. Use four #12 screws (items
“C”) and plastic anchors (items “A”) if necessary.
Note: Kit can be purchased from Southbend (part number 1176867).
2. Install eye-bolt (item “F”) to a frame member on the rear of the equipment. After checking carefully
behind the frame member for adequate clearance, drill a 1/4" hole through the frame member.
3. Thread hex nut (item “G”) and slide the washer (item “H”) onto the eye-bolt. Insert the eye-bolt through
the 1/4" drilled hole and secure with a washer (item “H”) and nylon lock nut (item “I”).
4. Using the spring-loaded snap hooks, attach the restraining device to the bracket and the eye-bolt.
5. Using the cable clamp (item “D”), adjust the restraining device extended length to prevent over-bending
or kinking of the appliance connector.