Southbend P32N-TT - Manual (Page 27)

P LATINUM S ERIES R ANGE
OWNER’S MANUAL 1185836 REV 8 (9/14) PAGE 27 OF 47
S TEP 5 : A TTACH F LUE R ISER AND S HELF A SSEMBLIES
Install the flue riser(s) using the following procedure (as shown in Figure 16).
1. Attach any salamander broilers and flue-riser-mounted cheese melters to appropriate sections following the
installation procedure in the manuals for those options.
2. Slide each flue riser down onto the brackets projecting from the back of the corresponding section(s) of the
sectional range. Secure the flue riser to the brackets with the four provided 1/4-20x3/4 hex-head bolts, flat washers,
and lockwashers. Also, secure the bottom edge of the flue riser to the top rear edge of the sectional range using the
provided #10 sheet metal screws.
3. If access to the interior of the flue riser is necessary to make gas connections, make those connections at this time.
Installation of Flue Riser
Figure 16
Slide the front of the flue riser down into
the brackets on the sectional range.
Secure the flue riser to the
brackets using the provided
fasteners. Also secure the
bottom edge of the flue riser
to the top rear edge of the
sectional range.
Attach the rear of the flue riser
to the front of the flue riser
using the provided fasteners.
I NSTALLATION