Southbend P32N-TT - Manual (Page 23)

P LATINUM S ERIES R ANGE
OWNER’S MANUAL 1185836 REV 8 (9/14) PAGE 23 OF 47
Removal of Shipping Hold-Down Brackets
Figure 12
S TEP 2 A: A TTACH L EGS
A set of four legs is packed with units ordered with legs. (For units ordered with casters, go to Step 2b.)
A threaded leg pad is fastened to the base frame at each corner. Each leg has a corresponding mating thread. The legs
can be adjusted to overcome a slightly uneven floor.
1. Raise the range sufficiently to allow the legs to be attached. For safety, “shore up” and support the range with an
adequate blocking arrangement strong enough to support the load.
2. Screw the legs into the holes in the centers of the leg pads (see Figure 13).
3. Lower the range gently onto a level surface. Never drop or allow the range to fall.
4. Go on to Installation Step 4.
Installation of Legs
Figure 13
Shipping
Hold-Down
Brackets
I NSTALLATION