SkyRC T6755 Charger - Manual (Page 6)

START
CELLS CAPACITY
BATT TYPE
Pb
Lilon
OPERATION
DISCHARGE
VOLT METER
CHARGE
START SETTING PRESET
LiPo
mAh
LiPo 6S C6.0A / D2.0A P1
CELLS CAPACITY
BATT TYPE
Pb
Lilon
OPERATION
DISCHARGE
VOLT METER
CHARGE
START SETTING PRESET
LiPo
mAh
LiPo 6S C6.0A / D2.0A P1
CELLS CAPACITY
BATT TYPE
Pb
Lilon
OPERATION
DISCHARGE
VOLT METER
CHARGE
START SETTING
LiPo 6S C6.0A / D2.0A
PRESET
LiPo
mAh
P1
OPERATION PROGRAM
How to operate the charger?
Browse - Touch the arrow ▲ and ▼ or and to browse all the selections
Confirm – Touch your selection on the screen to for confirmation
Start – Touch start button or touch and hold the operation program for 3 seconds to start
the program.
2. Battery Setting
1.Connection
2).Connecting The Battery
SKYRC T6755 comes with the built in
switching power supply. You can connect
the AC power cord directly to the main AC
socket. (100-240V AC). For attaching
directly to 12V car batteries. It is critically
important that you use a fully charged
13.8V car battery.
Important!!! Before connecting a battery it is absolutely essential to check one last time that
you have set the parameters correctly. If the settings are incorrect, the battery may be
damaged, and could even burst into flames or explode. To avoid short circuits between the
banana plugs, always connect the charge leads to the charger first, and only then to the
battery. Reverse the sequence when disconnecting the pack.
3).Balance Socket
Using terminal
clip attaching
to car battery
WARNING:
Failure to connect as shown in this diagram will damage this charger.
▲ ▲
The balance wire attached to the battery must be connected to the charger with the
blackwire aligned with the negative marking. Take care to maintain correct polarity! (See
the wiring diagram below.)
This diagram shows the correct way to connect your battery to the SKYRC T6755 while
charging in the balance charge program mode only.
There are 3 basic parameter settings you have to set according to your battery. They are
battery type, battery cells and battery capacity.
1).Battery type
2).Cells
3).Battery Capacity & Current
Here are the detailed procedures to make the charger work. All the screens and operations will
take LiPo-CHARGE program for example,
Please touch the arrow ▲ and ▼ to
browse six kinds of battery types and
find the right battery type. And the
selected one will be framed.
Please touch the arrow and to select the right battery cells count and touch
“CONFIRM” for confirmation. ▲ ▲
Please touch the arrow and to select the proper battery capacity and until it
matches your battery.
If your battery is 850mAh, for example, you could set this to 800mAh. The default
Charge Rate for lithium is 1C of capacity (equal to 0.8A for a 800mAh setting). But ▲ ▲
OPERATION PROGRAM
T6755 T6755 09 08
BATTERY CELLS
6S
CONFIRM
OPERATION PROGRAM
1 Connecting to Power Source ).
LiPo 6S C6.0A / D2.0A P1
ENTER
CAPACITY 2000 mAh
LiPo 6S C2.0A/D1.0A
CHARGE
CURRENT
DISCHARGE
CURRENT
2.0A
1.0A
P1