Simaudio 700i Integrated Amplifier - Manual (Page 7)

700i Reference Dual-Mono Integrated Amplifier
____________________________________________________________________________________
7
Unpacking
The MOON 700i integrated amplifier should be removed from its box with care.
The following accessories should be included inside the box with your integrated amplifier:
9 AC power cable
9 ‘FRM-3’ remote control with three ‘AAA’ batteries (USA and Canada only)
9 ‘SimLink’ cable with 1/8” mini plug terminations on each end
9 This owner’s manual
9 Warranty and product registration information (USA and Canada only)
Once the 700i is unpacked, inspect it thoroughly
and report any damage to your dealer immediately.
We suggest that you keep all of the original
packaging, storing it in a safe, dry place in case
you’re required to transport this product. The
customized packaging is specially designed to
protect the 700i from any potential damage during
transit
Please write the serial number of your new MOON 700i in the space provided below for future reference.
Serial No.: ________________
Installation & Placement
The MOON 700i Dual-Mono integrated amplifier is
both powerful and heavy. It requires reasonable
ventilation to maintain an optimum and consistent
operating temperature, especially since it will radiate
heat when driven hard. Consequently, it should be
placed in a location with empty space around it for
proper heat dissipation. You should never place
another component on top of this integrated
amplifier. As well, the integratedamplifier should be
placed on a solid level surface. You should avoid
placing it near a heat source or inside a closed
cabinet that is not well ventilated as this could
compromise the amplifier’s performance and
reliability. The 700i uses two large toroidal
transformers in its power supply; even though they
are well shielded, you should not place this
integrated amplifier too close to source components
sensitive to EMI, such as turntables, phono
preamplifiers and CD Players.
If the surface you have chosen isn’t perfectly level,
each of the four (4) cones of your 700i are height
adjustable; carefully using your fingers, you can
either raise each leg by turning the cone underneath
clockwise, or lower each leg by turning it
counterclockwise.
We strongly recommend that you leave these cones
mounted to the component at all times for reasons
related to both performance and aesthetics.