Simaudio 700i Integrated Amplifier - Manual (Page 13)

700i Reference Dual-Mono Integrated Amplifier
____________________________________________________________________________________
13
If you want to control the MOON 700i using a
wired aftermarket infrared remote control receiver
with a universal remote control, you can disable the
IR sensor located on the front panel as follows:
1. You may either continue where we left off in the
previous example by pressing “Setup” twice to
return to the main menu and the turn the
volume control until “INFRARED” appears in the
display OR enter into the “Setup” mode from the
beginning by pressing the “Setup” button and
rotating the volume control until “INFRARED”
appears in the display.
2. Press “OK” and “NORMAL” will appear in the
display.
3. To disable the MOON 700i’s front panel IR
sensor, rotate the volume control to alternate
from “NORMAL” to “DISABLED” .
4. Press “OK” and “SAVED” will appear briefly
in
the display followed by “INFRARED”
5. Press the “Setup” button to exit from the Setup
menu.
The MOON 700i is equipped with a rear mounted
IR input for use with aftermarket wired infrared
remote control receivers. In the event that you want
control the MOON 700i with a universal remote
control and NOT the one included (FRM-2), you can
change the RC-5 remote control system codes. This
procedure is recommended when you have a large
custom install setup that uses multiple integrated
amplifiers and/or preamplifiers that operate on the
RC-5 standard and you need to make each
component unique w.r.t. remote control operation –
up to 4 components. Before making the following
change, you should have a basic understanding
how to program a universal remote control. The
following example shows how to change the IR
codes that the MOON 700i will recognize:
1. You may either continue where we left off in the
previous example by pressing “Setup” twice to
return to the main menu and the turn the
volume control until “IR CODE” appears in the
display OR enter into the “Setup” mode from the
beginning by pressing the “Setup” button and
rotating the volume control until “IR CODE”
appears in the display.
2. Press “OK” and “DEFAULT” will appear in the
display.
3. To change the RC-5 system codes, rotate the
volume control to scroll through the available
sets of RC-5 compatible codes: “SYS11”,
“SYS14”, “SYS15”, and “SYS19”.
4. Once you’ve decided on one, Press “OK” and
“SAVED” will appear briefly in the display
followed by “IR CODE”.
5. From this point you can (i) exit from the Setup
procedure by pressing the “Setup” button again
and “EXITING” will appear in the display or (iii)
continue with the Setup procedure by disabling
the infrared remote sensor, changing the IR
codes, resetting the 700i back to factory default
status (see the following example), configure
the 12 Volt Trigger Output or configure more
inputs (examples on previous pages).