Rocktron Taboo Twin - Manual (Page 64)

61
To reload user data from a sequencer:
Connect a standard MIDI cable from the M
IDI
O
UT
of the transmitting sequencer to the M
IDI
I
N
on the receiving Taboo Twin.
Step 1
IMPORTANT
ð Do not allow a looping connection from the M
IDI O UT /T HRU of the receiving Taboo Twin back
to the M IDI I N of the transmitting sequencer.
With the M ENU button lit, turn the F UNCTION S ELECT control on the receiving Taboo Twin until
"MIDI DUMP/LOAD" is displayed.
MIDI DUMP/LOAD
Receiving Taboo Twin
Step 2
Play back the data stored on the sequencer. The Taboo Twin will display the data strings as it
is storing them. Each data string will appear with the word "LOADED". After all the user
data has been loaded, the Taboo Twin will display "LOAD COMPLETE". Do not play back
the data from the sequencer faster than it was loaded, as errors may occur (errors may also
occur if any knob is turned or any button is pressed before the message "LOAD COM-
PLETE" appears).
LOAD COMPLETE
Receiving Taboo Twin
Turn the P
ARAMETER
S
ELECT
control on the receiving Taboo Twin until "BULK DUMP/
LOAD" is displayed.
MIDI DUMP/LOAD
Receiving Taboo Twin
Step 3
Step 4