Rocktron VFS1 Single Footswitch User Manual
Vfs1, Footswitch

VFS1
FOOTSWITCH
Congratulations and thank you for yourpurcahse of the Rocktron VFS1 Footswitch. Although the VFS1
has many uses, it is mainly used to switch channels or turn effects on/off on your guitar amplifier
Descriptions:
The LED ON/OFF status changes each
time you press the switch. Press the switch
once to activate (LED turns ON). Press the
switch once more to deactivate (LED turns OFF)
A 9-Volt Battery powers the LED’s and is
accessable through the battery compartment
located on the bottom of the VFS1.
Use a standard 1/4” mono guitar cable to
make the connection from the pedal to the
footswitch jack on your amplifier or rack unit.
Use the VFS1 to change channels on your
amplifier or turn ON/OFF effects. It can also
be used as a switcher between amplifier and
rack systems, or as a switcher between two
amplifiers or an amp and a rack.
VFS1
FOOTSWITCH
Gainaic 2
Footswitch
Input
Footswitch
Input
VFS1
FOOTSWITCH
Guitar
Output
Amp
Input
Footswitch
Jack
Footswitch Jack
on back of amp
VFS1
FOOTSWITCH
FOOTSWITCH JACK
USE A STANDARD
1/4” MONO GUITAR
CABLE
ON/OFF SWITCH.
PRESS TO ACTIVATE
(ON/OFF). WHEN “ON” LED
WILL BE “LIT”.
ON/OFF LED