ParkZone PKZU2280 - Manual (Page 4)

4
Charging the Battery
The Battery Charging Process
1. Charge only batteries that are cool to the touch and are not damaged. Look at the battery to
make sure it is not damaged e.g., swollen, bent, broken or punctured.
2. The connector of the battery is specifically designed to only allow it to fit into the charge port
one way in order to prevent reverse polarity connection; however, check for proper alignment
and polarity before proceeding to the next step.
3. Gently press the battery connector into the charge port located on the front of the charger.
4. When you make the connection successfully, the green LED blinking on the charger will slow,
indicating proper connection.
5. Press the button on the charger; the red LED will illuminate, indicating charging has begun.
6. Charging a fully discharged (not over-discharged) 200mAh battery takes approximately
50–60 minutes.
7. When the battery is fully charged, the green LED will illuminate.
8. Always unplug the battery from the charger immediately upon completion of charging.
CAUTION: Overcharging a battery can cause a fire.
Your Ultra Micro Stryker comes with a
Celectra™ 2S 7.4V DC Li-Po Charger and 2-Cell
7.4V 200mAh 25C Li-Po battery. Please visit
www.horizonhobby.com for optional battery
adapters. Refer to battery warnings. It is
recommended to charge the battery pack
while you are inspecting the aircraft. The fl ight
battery will be required to confi rm proper
aircraft operation in future steps.
EN
CAUTION: Only use a charger specifi cally designed to charge a Li-Po battery. Failure to do
so could result in fi re causing injury or property damage.
CAUTION: Never exceed the recommended charge rate.
2S 7.4V 200mAh 25C
Lithium Polymer Batter y
LED Functions under normal operation
1. Green LED blinking with power connected but without battery ................. Standby
2. Green LED blinking ........................................................................................................ Battery is connected
3. Blinking Red LED at varying speeds ......................................................................... Charging
4. Red and Green LED blinking simultaneously ....................................................... Balancing
5. Solid Green LED ............................................................................................................... Full Charge
6. Red and Green LED fl ashing rapidly......................................................................... Error