ParkZone PKZU2280 - Manual (Page 10)

10
Bind your aircraft and transmitter before doing these tests (see Binding). Move the controls on
the transmitter to make sure aircraft control surfaces move correctly (Mode 2 shown).
After doing the Control Test, correctly set the failsafe. Make sure the transmitter controls are
neutral and the throttle and throttle trim are in the low position, then rebind the model to your
transmitter. If the receiver loses link to the transmitter, failsafe makes the controls and throttle
go to these settings made at binding.
Control Direction Test
EN
Up
Elevator
Left
Aileron
Right
Rudder
Down
Elevator
Right
Aileron
Left
Rudder