Maintenance after flying, En additional safety precautions and warnings, Nose wheel repairing/replacing nose – ParkZone PKZU2280 User Manual
Page 13

13
NOTICE: Always repair or replace the nose
when it is damaged to keep the model
fl ying correctly.
1. When damaged, pull soft nose cone from
glue and pin on front of fuselage.
2. Install nose cone on front of fuselage using
a small amount of foam-compatible CA.
Maintenance After Flying
1. Disconnect fl ight battery from the Receiver/
ESC (Required for Safety).
2. Power off transmitter.
3. Remove fl ight battery from aircraft.
4. Recharge fl ight battery.
5. Repair or replace all loose or damaged
parts.
6. Store fl ight battery apart from aircraft
and monitor the battery charge.
7. Make note of fl ight conditions and fl ight
plan results, planning for future fl ights.
EN
Additional Safety Precautions and Warnings
1. Remove and retain screw (A) from nose
wheel pant (B) and nose wheel (C).
2. Remove wheel from nose wheel pant.
3. Install wheel and screw in nose wheel pant.
Nose Wheel
Repairing/Replacing Nose
As the user of this product, you are solely
responsible for operating in a manner that
does not endanger yourself and others,
or result in damage to the product or the
property of others.
This model is controlled by a radio signal
subject to interference from many sources
outside your control. This interference can
cause momentary loss of control, so it is
advisable to always keep a safe distance in all
directions around your model. This margin
will help avoid collisions or injury.
• Always keep a safe distance in all
directions around your model to avoid
collisions or injury.
• Always operate your model in open
spaces away from full-size vehicles, traffi
c
and people.
• Always carefully follow the directions
and warnings for this and any optional
support equipment (chargers,
rechargeable battery packs, etc.).
• Always keep all chemicals, small parts and
anything electrical out of the reach
of children.
• Always avoid water exposure to all
equipment not specifi cally designed
and protected for this purpose. Moisture
causes damage to electronics.
• Never place any portion of the model in your
mouth as it could cause serious injury or
even death.
• Never operate your model with low
transmitter batteries.
A
B
C