ParkZone PKZ6680 - Manual (Page 9)

EN
The CG location is 75mm back from the leading edge of the wing. Install the
recommended fl ight battery with the end of the battery aligned with the rear
edge of the foam battery shelf. Make sure the fl ight battery is secured using
the hook and loop strap.
IMPORTANT: Always adjust the location of components in the fuselage to
achieve the recommended center of gravity. Do not fl y your aircraft if the
center of gravity is not at the recommended location.
Aircraft CG and weight is based on an E-fl ite 7.4V 1300mAh 20C battery
(EFLB13002S20) installed.
Center of Gravity (CG)
75mm
2.95 inches back from the
leading edge of the wing.
All aircraft carry a unique alphanumeric string that identifi es civil or military
aircraft. Your ParkZone
® Ka-8 sailplane includes two alphanumeric decal op-
tions. Option A (N15343) represents an aircraft registered in the U.S., while
Option B (D54332) represents an aircraft registered in Germany.
Application
1. Ensure the fuselage is clean.
2. Lift a decal from a sheet and carefully apply it to the aircraft.
3. Rub out from the center of the self-adhesive decal to remove bubbles.
1. Charge the fl ight battery.
2. Install the fl ight battery in the aircraft (once it has been fully charged).
3. Make sure the linkages move freely.
4. Perform the Control Direction Test with the transmitter. 5. Adjust the fl ight controls and transmitter.
6. Perform a radio system Range Check.
7. Find a safe and open area.
8. Plan fl ight for fl ying fi eld conditions.
Prefl ight Checklist
Decal Installation
Dual Rates
Your DSM2/DSMX full range transmitter features dual rates to help you select
the amount of travel that you want from the control surfaces.
High Rate Low Rate
Aileron 17mm up/15mm down 12mm up/11mm down
Elevator 16mm up/down 11mm up/down
Rudder 32mm left/right 22mm left/right
B
A
9