ParkZone PKZ6680 - Manual (Page 16)

EN
Problem Possible Cause Solution
Reduced fl ight time Flight battery charge is low Completely recharge fl ight battery
Flight battery damaged Replace fl ight battery and follow fl ight battery instructions
Flight conditions may be too cold Make sure battery is warm before use
Spoilers not fully retracted Center throttle trim and adjust clevises on spoiler servo so spoiler fully
retracts
Aircraft will not Bind
(during binding) to
transmitter Transmitter too near aircraft during binding process Move powered transmitter a few feet from aircraft,
disconnect and reconnect fl ight battery to aircraft
Aircraft or transmitter is too close to large metal object,
wireless source or another transmitter Move aircraft and transmitter to another location and attempt
binding again
The bind plug is not installed correctly in the bind port Install bind plug in bind port and bind the aircraft to the transmitter
Flight battery/Transmitter battery charge is too low Replace/recharge batteries
Bind switch or button not held long enough during bind
process Power off transmitter and repeat bind process. Hold transmitter bind
button or switch until receiver is bound
Aircraft will not con-
nect (after binding)
to transmitter Transmitter too near aircraft during connecting process Move powered transmitter a few feet from aircraft, disconnect and
reconnect fl ight battery to aircraft
Aircraft or transmitter is too close to large metal object,
wireless source or another transmitter Move aircraft and transmitter to another location and attempt
connecting again
Bind plug left installed in bind port Rebind transmitter to the aircraft and remove the bind plug before
cycling power
Aircraft bound to different model memory (ModelMatch TM
radios only)
Select correct model memory on transmitter
Flight battery/Transmitter battery charge is too low Replace/recharge batteries
Transmitter may have been bound using different DSM
protocol Bind aircraft to transmitter
Control surface does
not move Control surface, control horn, linkage or servo damage Replace or repair damaged parts and adjust controls
Wire damaged or connections loose Do a check of wires and connections, connect or replace as needed
Transmitter is not bound correctly or the incorrect model
was selected Re-bind or select correct model in transmitter
Flight battery charge is low Fully recharge fl ight battery
Regulator damaged Replace regulator
Controls reversed Transmitter settings are reversed Perform the Control Direction Test and adjust the controls on
transmitter appropriately
Troubleshooting Guide
16