ParkZone PKZ1570 - Manual (Page 4)

4
Attaching the Wing
In order to attach the wing of your P-51D, please follow
these simple instructions:
1. Locate the two wing securing screws in the box.
2. Turn over the fuselage so you are looking at the
bottom. Do the same with the wing (also silver side).
3. Carefully mate the aileron extension from the receiver
to the lead coming from the wing. The plug is
polarized to fit one way.
Note : The aileron extension includes servo reversing
so if this is not attached correctly, or if the extension
is not used, the ailerons will be backwards when
transmitter input is given. Always function check this
prior to each flight.
4. Carefully slide two points of belly scoop on the
trailing edge of the wing into the two notches inside
the rear of the fuselage.
5. Slide the joined aileron extension inside the fuselage
so that it will not become pinched in between the
wing and fuselage when securing the wing.
6. Slide the bottom of leading edge of the wing into
the fuselage as shown, making certain it is perfectly
centered. This must be done correctly in order to
allow the two screws to thread into the fuselage.
Once you are certain the wing is centered, tighten
the two screws to secure the wing.
7. The wing is correctly installed when no gap exists
between wing and fillet.
Step 3