Palram SUNTO - Manual (Page 4)

SUNTOP ® 177 / 51 (5,6 waves)
Installation Guide
13.02.2006 4
Drilling
Hole diameter must be 3-4 mm larger than the screw diameter.
Support the sheet in the vicinity of the hole and clean dust and
splinters away.
The drill should be held perpendicular to the sheet surface.
Applying the Sealing tape
Clean the surface before applying the tape.
Apply the tape slowly, uniformly and with no stresses.
Apply one tape line along the screw holes location or 2 tape lines on both sides of the screw holes
line.
Important Notes
Be sure to install the UV protected side facing the sun radiation.
Avoid any stress source.
Pre drilled holes – Oversized holes should be 3-4mm wider than the screw diameter.
Do not over-tighten.
Use only approved accessories, including rubber washers, silicones, sealing strip, closure fixtures etc.
Soft PVC washers looking exactly like EPDM washers are not compatible with Polycarbonate sheets.
Avoid contact with non-compatible chemicals and materials.
For information about accessories, please refer to the CATALOGUE OF FINISHING
ACCESSORIES.
Inasmuch as Palram Industries has no control over the use to which others may put the material, it does not guarantee that the same results as those described
herein will be obtained. Each user of the material should make his own tests to determine the material's suitability for his own particular use. Statements
concerning possible or suggested uses of the materials described herein are not to be construed as constituting a license under any Palram Industries patent
covering such use or as recommendations for use of such materials in the infringement of any patent. Palram Industries or its distributors cannot be held
responsible for any losses incurred through incorrect installation of the material. In accordance with our Company policy of continual product development you are
advised to check with your local Palram Industries supplier to ensure that you have obtained the most up to date information.
Europe
UK
Israel
USA
Australia
Far East
EUROPE
PALRAM EUROPE LTD.
Tel (44) 1302 380 777
Fax (44) 1302 380 788
[email protected]
PALRAM UK
Tel (44) 1302 380 738
Fax (44) 1302 380 739
[email protected]
ISRAEL
PALRAM ISRAEL LTD.
Tel (972) 4 8459 900
Fax (972) 4 8459 980
[email protected]
USA
PALRAM Americas
Tel 610 285 9918
Fax 610 285 9928
[email protected]