Suntop – Palram SUNTO User Manual
Page 3
SUNTOP
®
177 / 51 (5,6 waves)
Installation Guide
13.02.2006
3
Crest fixing - Self-drilling ¼”x 3
1
/
2
” screw.
Recommended washer/gasket: 25mm diameter- galvanized / aluminum /
stainless
metal washer attached to EPDM rubber gasket of 55 to 65 shore hardness.
Never use PVC washers or any unapproved material.
PALRAM washers are highly recommended.
When installing a curved roof it is recommended to use a compatible crest rider with EPDM attached
gasket.
pre-drill the screw holes in the SUNTOP sheets, 3-4 mm bigger than the screw diameter.
Fastening Tips
Use adjustable electric screwdriver.
The screw must be installed perpendicular
to the SUNTOP sheet.
Important - Do not over-tighten!
Cutting / Sawing tools
Table or Portable circular saw with small teeth.
When Sawing, use high blade speed and slow feed rate.
Support the sheet in the vicinity of the cut and clean dust
and splinters away.
Handling and Storage (Packed sheets)
Store in a shaded place. Protect from direct sunlight and rain.
Avoid covering the sheets with heat absorbing materials.
Avoid contact or storing in incompatible chemicals environment.
Protect the sheets from any damage.
Accessories
Use only PALRAM approved accessories
Compatible Silicone.
Butyl Rubber or Expanding Sealing tape.
Closure Fixtures.