Mossberg Maverick 8 and 9 - Manual (Page 18)

16
accu choKe TuBes
gauge iTem # leaD shoT paTTerns
12 95190 Full
12 95195 Modified
12 95200 Imp. Cylinder
12 95235 Skeet
12 95267 XX Full Turkey(lead only)
12 95245 Improved Modified
accu-sTeel™ choKe TuBes
(88™ moDels only)
ACCU-STEEL TUBES - have been specifically designed for exceptional endurance and
controlled patterning of steel shot.
These tubes will provide the best pattern results for the steel shot sizes stamped on
each tube.
Lead shot may be used with ACCU-STEEL tubes; however, pattern tests should be
made to compare the pattern change.
To
remove choke tube, loosen with a choke wrench provided, turning counterclockwise.
When loose, remove completely with fingers, put choke on a clean dry surface.
To
install choke tube, first screw the tube clockwise into barrel by hand and then tighten
the tube until snug with a choke wrench. Do not use excessive force when installing.
Tube tightness should be checked periodically.
ACCU-STEEL tubes protrude beyond the muzzle and are designed specifically for
steel
shot. Choke designations are marked on each tube for specific steel shot sizes.
accu-sTeel™ choKe TuBes
gauge iTem # sTeel shoT paTTerns
12 95110 Full forT,F,BB,#1,2
12 95115 Full for #4,6
12 95117 Extra-Full forT,F,BB,#1,2
12 95120 Modified for All Steel Shot Sizes
accu-mag™ choKe TuBes
( 91™ moDels only)
ACCU-MAG choke tubes are internal, flush fitting choke tubes designed for use with
LEAD and STEEL shot. Each durable tube is clearly marked, as a guide, with the lead
and the steel shot pattern it will produce.
To
remove a choke tube from the muzzle of the barrel, loosen with the choke wrench provided,
turning it counterclockwise. When choke tube is loosened, remove it completely with fingers.
Put choke tube on a clean, dry surface.
To
install choke tube, screw the tube clockwise into the barrel by hand and then tighten the
tube until snug with choke wrench. These tubes fit competely inside the barrel when
properly installed. Do not use excessive force when installing. Tube tightness should
be checked periodically.
66626.indd 18 3/10/09 1:32:58 PM