Mossberg Maverick 8 and 9 - Manual (Page 11)

9
CAUTION: Before performing any further disassembly, take time to study how the internal
components are arranged inside the receiver.
DisassemBly of inTernal receiVer componenTs
CAUTION: Pay special attention to the position of the bolt, bolt slide and action slide bar
assembly during this portion of the disassembly, as the parts must be in the same
relationship during reassembly.
Remove the cartridge interrupter from the ejection port side and cartridge stop from
the opposite side. (It may be necessary to tap the sides of the receiver lightly to release
these parts) (Fig. 9).
Move the forearm/action slide assembly rearward so that the bolt assembly and bolt slide
are three quarters of the way rearward. When the bottom of the bolt slide is aligned with the
clearance cuts in the sides of the receiver, lift the bolt slide upward and out of the receiver
(Fig. 10).
Remove the bolt assembly by sliding it forward and out of the receiver assembly through
the barrel opening at the front of the receiver (Fig. 11-A).
→
→
66626.indd 11 3/10/09 1:32:38 PM