Mossberg Maverick 8 and 9 User Manual
Page 10
Trigger housing remoVal
Position the shotgun on a clean surface with the trigger guard upward. With a blunt
object (no greater than 3/16” [4.76 mm] diameter), push out the small diameter trigger
housing retainer pin located on the side of the receiver, approximately a 1/2” (12.7 mm)
below the rear of the trigger guard (Fig. 8).
Remove the trigger housing assembly by lifting the rear portion upward first.
The trigger housing is a complex assembly and must not be disassembled.
Disassembly should only be performed at an authorized Product Service Center or
by a qualified gunsmith.
8
Do not pull the trigger and allow the hammer to fall when the trigger housing
assembly is removed from the receiver. To do so may result in personal injury
or damage to the assembly.
fig. 8
▲
▲
66626.indd 10
3/10/09 1:32:36 PM