Lumagen Radiance XE-3D - Manual (Page 42)

Section 8 – Miscellaneous Commands
RadianceXE rev 091211 36
Saving the Configuration
Save
NOTE:
If a Save command is not executed after making changes, the changes will be
lost when the unit is put into standby power mode, or if power is interrupted.
Permanently save the current configuration. Note that, once saved, the configuration is retained even if the
unit is disconnected from power. The configuration from the previous save is retained to allow one level of
save-undo. You can use the Radiance Configuration Utility found on the Lumagen.com support page to store
a configuration file on your PC. The command is:
MENU → Save → Save → OK → OK
Undo
Revert to the configuration over-written by the last Save command. Repeating the Save Undo command
toggles between the last two saved configurations. The command is:
MENU → Save → Undo → OK
Restore ISF calibration
During calibration, the video technician can save the resulting Lumagen configuration to a special hidden
configuration memory. This command restores that configuration in the event that the user inadvertently
changes the configuration. A Save is required to make the restore permanent. The command is:
MENU → Save→ Restore ISF→ OK
Revert To Factory Settings
Set all parameters to factory defaults. A SAVE is required to make the settings permanent. The command
is:
MENU 0 9 9 9
Or MENU → Save→ FactoryReset → OK