Lumagen Radiance Mini-3D - Manual (Page 41)

Section 10 – Command Interface
Radiance Mini rev 091211 33
Section 10 – Command Interface
Direct Commands
Direct Commands are entered by using the Lumagen remote control or RS232 interface.
See Radiance Tech Tip 13 “Direct Commands and Menu Shortcuts” which contains a complete list
commands. This Tech Tip is available for download at
http://www.lumagen.com .
Output Vertical Resolution
480p: MENU 0 2 1 Progressive with 480 active scanlines
540p: MENU 0 2 2 Progressive with 540 active scanlines
720p: MENU 0 2 4 Progressive with 720 active scanlines
768p: MENU 0 2 5 Progressive with 768 active scanlines
1080p: MENU 0 2 7 Progressive with 1080 active scanlines
1080i: MENU 0 2 8 Interlaced with 1080 active scanlines
Output Mode Commands
Output 2D MENU 0 3 0 Set output mode to 2D
Output 3D-SBS MENU 0 3 1 Set output mode to 3D Side-By-Side
Output 3D-TB MENU 0 3 2 Set output mode to 3D Top-Bottom
Output Vertical Rate
Set vertical rate: MENU 0 4 (50Hz, 60Hz) OK
Output Aspect Ratio
Output aspect ratio: MENU 0 6 value OK Example: For 16:9 enter178
Miscellaneous Commands
S/W Rev MENU 0 9 0 3 Display software revision and serial-number
Menu timeout MENU 0 9 0 5 Toggle menu timeout. Short (default) or long (saved)
Service Mode MENU 0 9 1 0 Toggle SERVICE MODE. (not saved)
Reinterlace Off MENU 0 9 4 0 Turns reinterlacing off
Reinterlace On MENU 0 9 4 1 Turns reinterlacing on
Toggle field order MENU 0 9 4 2 Toggles field order for reinterlacing
Unlock menu MENU 0 9 1 5 Can also be selected using menu
Output defaults MENU 0 9 9 8 Reset current output to default for current resolution
Factory defaults MENU 0 9 9 9 Reset to factory default (Must “Save” to make permanent)
Menu Shortcuts
See Radiance Tech Tip 13 “Direct Commands and Menu Shortcuts” which contains a complete list
commands. This Tech Tip is available for download at
http://www.lumagen.com .
IR Command List
See Radiance Tech Tip 12 “IR Command Interface” which contains a complete list of IR commands.
This Tech Tip is available for download at
http://www.lumagen.com .
ASCII Command List
See Radiance Tech Tip 11 “RS232 Command Interface” which contains a complete list of RS232
commands. This Tech Tip is available for download at
http://www.lumagen.com .