Livorsi DTS Controls - Manual (Page 8)

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 8 of 12
1. Connect the “LEVER 1” connector on the DTS command module harness to the
shift potentiometer on the control console.
2. Connect the “FOOT THROTTLE” connector on the DTS command module
harness to the throttle potentiometer on the control console using the adapter
harness (P/N 89-891963A01).
3. Connect the trim adaptor harness to the DTS command module harness.
4. Connect the bullet connectors on the trim adaptor harness to the trim
connections on the control.
5. Connect the start/stop switch (optional), warning horn, lanyard stop switch and
key switch to the appropriate connections.
6. Make all the other DTS command module harness connections following the
instructions included with the DTS Command Module kit.