LINK Systems OmniLink 5000 - Manual (Page 11)

April 12, 2012 Manual Version 1.1 2.5
SPM
SPM
0
0 Order
Counter
PC STATUS
READY TO STROKE
Counter OFF
Auto
Setup
CHANGE
NUMBER
SPM
SPM
0
0 Order
Counter
PC STATUS
READY TO STROKE
Counter OFF
Auto
Setup
SUPPLY
ACCESS
CODE
SPM
SPM
0
0 Order
Counter
PC STATUS
READY TO STROKE
Counter OFF
Auto
Setup
CHANGE
NUMBER
SPM
SPM
0
0 Order
Counter
PC STATUS
READY TO STROKE
Counter OFF
Auto
Setup
SELECT
STEP A: SELECTING PARAMETER TO BE CHANGED STEP B: SELECTING USER NAME
STEP C: ENTERING USER PASSWORD STEP D: CHANGING PARAMETER
PRESS SUPPLY
ACCESS CODE KEY
Slide Adjust #1 (ON)
Setpoint:
Actual
Shutheight
Fault:
Status:
None
In Position
20.000
20.000
in
in
Slide Adjust #1 (ON)
Setpoint:
Actual
Shutheight
Fault:
Status:
None
In Position
20000
20.000
in
in
SELECT A USER NAME
USER NUMBER ONE
USER NUMBER TWO
USER NUMBER FIVE
Setpoint:
Actual
Shutheight
Fault:
Status:
None
In Position
20.000
20.000
in
in
USER NUMBER ONE CODE _______
Slide Adjust #1 (ON)
Setpoint:
Actual
Shutheight
Fault:
Status:
None
In Position
20.000
in
in
Slide Adjust #1 (ON)
__.___
Figure 2.2: Example Password Entry Sequence
When operating in the Key Only mode the key switch is the only means available to access the restricted
items. All restricted items are accessible when the RUN/PROG key switch is switched to the PROG
position.
When operating in the “Key or Password” mode, the key switch is one of the means available to access
the restricted items. All restricted items are accessible when the RUN/PROG key switch is switched to
the PROG position.
When operating in the “Key and Password” mode, the key switch and password must be used to access
the restricted items. In this mode, the user will be granted access only to the restricted items that have
been assigned to him.
Section 2.2.6.2 Password System Operation
Figure 2.2 displays a typical password entry sequence. This example shows the steps necessary to
change a slide adjust setpoint. This is typical for password entry for all restricted items.