Lingenfelter L850161410 Camaro Rear Valance v0.8 - Manual (Page 8)

Page 7.
19. Using the M6 X 1mm studs located on the
sides of the LPE rear valance, mark the locations
on the rear bumper that will be drilled out in the
next step.
20. Using a 0.25” drill bit and drill, drill out both
sides of the bumper that were marked in the pre-
vious steps. You will want to drill from the inside
of the bumper.
17. Use a power drill (or equivalent) with a
0.25” drill bit to drill out the holes required.
18. Using a 7mm socket and ratchet, install
the LPE valance using the holes that were drilled
in the previous step. Torque the supplied M6 X
1mm nuts to 89 in-lb (10 N-m).