Lingenfelter L850161410 Camaro Rear Valance v0.8 - Manual (Page 4)

Page 3.
1. Pop the trunk lid. Prepare a clean work
surface for when the rear bumper is removed
Using a pry tool (or equivalent) remove the pop
rivets shown, located above the passenger and
driver side tail lights. Make sure not to damage or
lose them as they will be used later to re-install
this cover.
2. Once the cover is removed, disconnect the
tail light wiring harness electrical connectors on
both sides of the bumper.
3. This illustration shows the location of the
bolts that need to be removed in order to remove
the bumper.
4. Using a Torx 20 socket and ratchet, re-
move the two (2) bolts inside the wheel wells on
the driver and passenger sides of the vehicle.