Labconco Purifie Horizontal Clean Benches 36125 Series - Manual (Page 58)

54
Product Service 1-800-522-7658
Chapter 7: Modifying Your Clean Bench
Installing the IV Bar
1. Locate the screws already installed in the underside
of the canopy, located between the UV light and the
diffuser.
On 3- and 4-foot units, there will be four screws for
the IV bar.
On 6-foot models, there are a total of eight screws
for two IV bars.
2. Remove and save these screws from the canopy.
Placing the screws through the holes in the IV bar,
tighten the screws, securing the IV bar in place.
Installing the Vinyl Curtain
Kit
The vinyl curtain kit allows the user to close off the
work area of the clean bench when not in use.
1. Before beginning, identify the kit you have selected.
Width Catalog #
3' 3773800
4' 3773801
6' 3773802
2. Turn off the clean bench.
3. Clean the front edge of the work surface and the
lower edge of the front. Attach the self-adhesive
Velcro
® strips to the front of the work surface and
to the dress panel, as shown in Figure 7-1.
4. Place the vinyl curtain in position and press the
Velcro strips together to secure the curtain in place.
4' 3'
6'