Konig Electronic High definition DVB-S2 plug-in receiver - Manual (Page 14)

4. Press the green key to pop up the satellite window. Since it’s the same
operation as the above Edit Satellite Window, Please read there for
operation instructions.
5. Press the blue key to pop up the dialogue box “Are you sure you want to
delete?”. Select the Yes option and press the OK key to delete the
selected satellite. You can cancel this operation by selecting the NO
option.
2.3 Antenna Setup
Part A: Fixed
Suppose that you have selected Fixed Antenna in the Antenna Connection
window.
1. Satellite: All selected satellites in the satellite list are displayed in this
item. Press the keys to select the circled satellite. Or press the OK
key to open the drop-down list, then select the desired satellite in the list
and press the OK key to confirm.
2. LNB Freq, Transponder, DiSEqC 1.0, DiSEqC1.1: The same operation as
above.
3. 22K, 0/12V, polarity: you can press the keys to select what is
circled.
Part B: Motor
Suppose that you have selected Motor Antenna in the Antenna Connection
window.
1. LNB Type: Select the proper LNB type.
2. Motor Type: Select between DiSEqC1.2 and USALS. If you select
DiSEqC1.2, the following Local Longitude and Local Latitude items will
turn grey.
3. Delete All: Press the OK key to pop up the dialogue box “Are you sure
you want to clear the set satellite position of this tuner?”. Press the OK
key on the Yes option to clear all the memory of satellite positions th
connected to the current tuner.
at are
4. Motor Settings: Press the OK key to enter the Motor Settings window.
Satellite: Press the keys to select the circled satellite. Or press the
OK key to open the drop-down list, then select the desired satellite in the
list and press the OK key to confirm.
Transponder: The same operation as above.
Position No., & Save: The range is from 0 to 63. “0” denotes the original position.
You can select the proper value when you rotate the antenna.
14