Kipp&Zonen Brewer MkIII User Manual
Page 37
MKIII SERVICE MANUAL
32
Type save
a number should appear. This tell you how many configuration writes you had left
when the save command was issued. The number of configuration writes left is one less then the
number displayed.
The number is ‘4’ should be displayed.
Go to Load mode by typing loadmode
The display will eventually display [using load mode at 9600 baud, on com 1:
tracing is off ]
Go into Cosmac mode by typing cosmacmode
A number of messages will appear and eventually the motors should initialize and it is ready to run
the BREWER operating program and display [using cosmac mode at 1200 baud, on com
1: tracing is off ]
type quit
to get out of Brewcmd
To run the BREWER operating program type BREWER