DigiPower ePowerSwitch User Manual
Page 32
32
5. The PPP connection is useful if it
is not possible to make a direct
network connection to the
iSwitch. An external modem is
needed to connect to the front
serial port of the iSwitch. The
iSwitch support two ways using
modem to connect directly.
ISP
After dialing in the remote user
must hang up after the third ring.
Based on the information that the
user puts into the PPP
configuration, the iSwitch will
automatically dial up to the
designated ISP and send an
email to the designated email
address with the assigned IP
address from the ISP. The user
may browse and control the
iSwitch with this dynamic IP
address. When the user is ready
to exit click the "Disconnect Now
" button at the bottom of the
screen.
PPP
Both side are connected by
modem.
NOTE: The user must
complete one of the Setup
Procedures and fill in all of the
information in the PPP
Configuration before the Dial-
up Function will work.
ISP Mode
PPP Mode