beautypg.com

Telnet configuration – DigiPower ePowerSwitch User Manual

Page 25

background image

25

Telnet Configuration


This section will guide you through finishing the configuration of the iSwitch using Telnet.

NOTE: You must complete the appropriate Setup Procedure before proceeding with the Telnet Configuration.

NOTE: You must have given the iSwitch an IP Address.

NOTE: The connection by telnet client limits only 2 users.

NOTE: Telnet client connects to CIC card will be timeout over 75 sec.

The Ethernet cable is connected to the iSwitch and the iSwitch is on.

1. From the Desktop open the Start menu. Pick Programs and then open the MS-DOS Prompt.

2. This is an example. At the MS-DOS Prompt type telnet 192.166.7.19 (IP Address). Then hit enter.

3. Next you will be asked for the User Password. The default password is admin. Enter the password, then

hit enter.