HITEC Lynx 3D - Manual (Page 9)

EDIT EDIT
EDIT EDIT
Timer:
The timer can be selected to count up or down. Leave the setting at zero if you wish to count up. To
count down, select the amount of time you wish from 1 - 60 minutes using the “Data” key inc/dec
buttons. Once you have selected the time, it can be activated by pressing the “Edit” DN key after you
are out of the programming menu.
Idle Up:
This feature is typically used with gas and/or nitro powered cars or boats. Primarily at start up when
the engine is cold. By using the throttle trim with the idle up switch selected to the right, you can
select from a 0 - 50% throttle increase.
Racer Tip
Racer Tip
You can use the timer two ways, to count up or count down. If you want to see how long
your car will run, use the count up setting. If you are looking to simulate race conditions,
set it to count down, normally 4 or 5 minutes. There will be an audible tone each minute
and a countdown for the last 10 seconds. This way you can tell how the car feels at the
end of a simulated race and see if you have the proper gearing. If your car has slowed
substantially, before or at the end of the countdown, gear down a tooth or two on the
motor pinion.
The idle-up is used primarily with gas or nitro powered vehicles. Start off at 10% and
adjust from there. The purpose is to keep a cold engine running, similar to a choke in a
real car. Keep is on for about a minute, or until the engine is warmed up. Note: The
idle-up can also be used as the primary throttle trim and will not affect the end points like
the standard trim. Use this only if you are continually adjusting the drag brake on your
vehicle.
XX 2 SL X 00:0
0
ID-UP
TIMER MODEL
ON
POINT TIMER
ID-UP
ABS
CHANNEL
XX X 0
2 % 00:0
0
8
IDLE-UP TIMER MODEL SELECT BLINKING
DATA : 0 - 60MINUTE
DEFAULT : 00
TIMER VALUE NOT SETTING : UP COUNTER
TIMER VALUE SETTING : DOWN COUNTER
BLINKING
DATA : 0 - 50%
DEFAULT : 0%
KEY : DATA DEC/INC
TIMER IDLE-UP A.B.S.