HITEC Lynx 3D - Manual (Page 8)

EDIT EDIT
EDIT EDIT
EDIT EDIT
Model Reset:
This feature will allow you to reset any model back to the factory default setting. You must select the
model to be reset in the model select “SL” screen. Once you have selected the proper model, push
the “Data” inc/dec keys simultaneously, there will be an audible “beep” to verify reset.
Model Copy:
This feature allows you to copy a pre-exiting program to another model number. The model you wish
to copy “From” must be selected in the model select “SL” screen. Then using the “Aux.” +/- keys, you
can select the model you wish to copy “To”. Once you have selected the proper models push the
“Data” inc/dec keys simultaneously and there will be an audible “beep” to verify copy.
Model Select:
This feature associates a number to the model. The letters “SL” will appear on the screen with a
blinking number 0 - 9. These are your model numbers; they can be adjusted by using the “Aux.”
+/- keys to select the model you wish to program and use.
Racer Tip
To help remember which model is which number, use a little round sticky dot you can buy
at most stationary stores. Mark the model number and stick it on top of the receiver.
COPY MODEL
RST
EPA
CHANNEL
X X
RL X
$XX X X
%
COPY MODEL MODEL
SL X X X
RST
RL X
XX:X X TIMMER COPY X X MODEL
SL X
MODEL
7
DATA : 0 - 9
BLINKING
COPY RST EPA
MODEL SELECT COPY RST
MASTER
SLAVE DATA : 0 - 9
TIMER MODEL COPY MODEL SELECT
DATA : 0 - 9 SELECT : CHANNEL KEY
BLINKING