HITEC Lynx 3D - Manual (Page 5)

Fast Charging TX Battery:
Although Not recommend for normal charging, it may become necessary to fast charge the transmit-
ter battery if it becomes drained or you neglect to charge them overnight. This can be done with a
peak charger but the battery must be removed from the battery box and connected directly to the
charger. This is done by using a female “S” connector # 57343s. It is recommended the charge rate
not exceed 1.5 Amps for a quick charge.
Dry Cell Version:
Some versions of the Lynx 3D may not include NiCads and you will be required to use AA Alkaline
batteries. Place the batteries in the battery holder paying close attention to the polarity. Once the
batteries are installed properly the battery holder may be placed back in the transmitter for use.
(Warning: Do not attempt to recharge Alkaline batteries, they will explode).
Left Handed Operation:
The Lynx 3D is capable of converting from right to left handed operation. To do so please refer to the
diagram below.
4