HITEC Aggressor SRX - Manual (Page 9)

5. Receiver Servo Connections
EODFN#+0,#######
SRZHU#EDWWHU\# (Not included)
7.2V
UHG#+.,#######
VWHHULQJ#VHUYR
\HOORZ#+.,########
Eoxh#+0,#######
.
0
PRWRU##########
ZLWK#314xi#
FDSDFLWRU####
Electric Car Installation
ESC
(Not included)
RECEIVER
CH1
CH2
VWHHULQJ#VHUYR
WKURWWOH#VHUYR# (Not included)
Gas/Nitro Car Installation
RECEIVER
CH1 CH2
BATT
EDWWHU\#
4.8~6.0V
Note: Only one battery should be
connected at a time.
(Not included)
(Not included)
(Not included)
A) Receiver
- HFS-03MM Single Conversion
- You can use a separate receiver 4.8v - 6V battery pack if required for your particular model.
This battery is typically only used with a gas or nitro powered vehicles to supply power to the receiver.
Connect as shown.
- Note: If using an electronic speed control, it will supply the power to the receiver through the
connector plugged into channel #2.
- Be aware you should keep your receiver antenna at least 2" away from any power wires to
prevent potential interference.
- Route the antenna up an antenna tube as typically shown in your vehicles instructions.
- Warning: Be sure not to cut off any excess antenna wire, as it will shorten your operating range.