HITEC Aggressor SRX - Manual (Page 7)

L) Grip Pad
- The removable grip pad helps keep your hand secure on the radios pistol grip handle.
- The Grip Pads are available in assorted colors and sizes to customize the look and feel of your radio.
M) Module
- The replaceable module located in the back of the transmitter contains the
frequency crystal and frequency band of the radio.
- Crystals may be interchanged if permitted.
- The Spectra synthesized module is available in certain radio system versions,
or it can be purchased separately.
- The Spectra module will allow any channel to be selected within the 75MHz band.
- To remove the module, press the tabs with your thumb and finger while pulling it outward.
- Note: Wiggle the module to help ease its removal.
N) Charging Jack
- The transmitter charging jack located under the power switch is for use with the Hitec optional
CG-25 charger. The charger can be purchased separately if using rechargeable batteries.
- (See "Recharging Batteries" for more information about this feature.)
- Warning: Do not attempt to charge alkaline batteries; they may explode.
O) Steering Wheel
- Used to control the steering of your vehicle.
P) Steering Tension Adjustment
- Used to tighten or loosen the tension of the steering wheel.
Q) Throttle Trigger
- Used to control the throttle and braking of your vehicle.
- Pull the trigger for throttle and push it forward for braking or reverse
when using a reversing Electronic Speed Control.
R) Brake Limiter
- Used to limit the physical "braking travel" of the trigger.
Grip Pad
K) Antenna
- Always extend your antenna before turning your transmitter on.
- The antenna may be removed by turning counter clockwise.
- Warning: When collapsing your antenna, never push it from the top; it may bend.